Matter and Radiation at Extremes

2020—Transformative science in the pressure dimension

Mao Ho-Kwang, Chen Bin, Gou Huiyang, Li Kuo, Liu Jin, Wang Lin, Xiao Hong, Yang Wenge

2021, 6(1) doi: 10.1063/5.0040607

Abstract(119) FullText HTML (47) PDF(4)

Abstract:

Matter and radiation at extremes: Prospects and impacts

Koenig Michel, Crandall David, Mao Ho-Kwang, Lan Ke, Hoffmann Dieter H. H., Zhang Weiyan

2021, 6(1) doi: 10.1063/5.0041011

Abstract(179) FullText HTML (63) PDF(3)

Abstract:

Compact broadband high-resolution Compton spectroscopy for laser-driven high-flux gamma rays

Zhang Zhen-Chi, Yang Tao, Hu Guang-Yue, Li Meng-Ting, Luo Wen, An Ning, Zheng Jian

2021, 6(1) doi: 10.1063/5.0026005

Abstract(155) FullText HTML (55) PDF(6)

Abstract:
A compact broadband Compton spectrometer with high spectral resolution has been designed to detect spectra of laser-driven high-flux gamma rays. The primary detection range of the gamma-ray spectrum is 0.5 MeV–13 MeV, although a secondary harder gamma-ray region of 13 MeV–30 MeV can also be covered. The Compton-scattered electrons are spectrally resolved using a curved surface detector and a nonuniform magnetic field produced by a pair of step-like magnets. This design allows a compact structure, a wider bandwidth, especially in the lower-energy region of 0.5 MeV–2 MeV, and optimum spectral resolution. The spectral resolution is 5%–10% in the range 4 MeV–13 MeV and better than 25% in the range 0.5 MeV–4 MeV (with an Al converter of 0.25 mm thickness and a collimator of 1 cm inner diameter). Low-Z plastic materials are used on the inner surface of the spectrometer to suppress noise due to secondary X-ray fluorescence. The spectrometer can be adjusted flexibly via a specially designed mechanical component. An algorithm based on a regularization method has also been developed to reconstruct the gamma-ray spectrum from the scattered electrons.

Precise wavelength measurements of potassium He- and Li-like satellites emitted from the laser plasma of a mineral target

Ryazantsev S. N., Skobelev I. Yu., Filippov E. D., Martynenko A. S., Mishchenko M. D., Krůs M., Renner O., Pikuz S. A.

2021, 6(1) doi: 10.1063/5.0019496

Abstract(224) FullText HTML (88) PDF(5)

Abstract:
Atomic models of high-Z multicharged ions are extremely complex and require experimental validation. One way to do so is to crosscheck the predicted wavelengths of resonance transitions in He- and Li-like ions against precise spectroscopic measurements that use the spectral lines of H-like ions for spectra calibration; these reference data can be modeled with outstanding precision. However, for elements with Z of at least 15, it is quite difficult to create a hot dense plasma with a large concentration of H-like charge states. To mitigate this issue, the suggestion here is to use as laser targets particular minerals comprising elements with moderate (between 15 and 30) and low (less than 15) Z, with emission from the latter delivering perfect reference lines over a whole range of He- and Li-like moderate-Z emission under examination. This approach is implemented to measure the wavelengths of resonance transitions (1snp → 1s² for n = 2, 3) in He-like K ions and their dielectronic satellites by irradiating plates of orthoclase (KAlSi₃O₈) with 0.5-kJ subnanosecond laser pulses. X-ray spectra of the laser-generated plasma contain the investigated lines of highly charged K ions together with precisely known reference lines of H-like Al and Si atoms. The K-shell spectral line wavelengths are measured with a precision of around 0.3 mÅ.

Experiments and simulations of isochorically heated warm dense carbon foam at the Texas Petawatt Laser

Roycroft R., Bradley P. A., McCary E., Bowers B., Smith H., Dyer G. M., Albright B. J., Blouin S., Hakel P., Quevedo H. J., Vold E. L., Yin L., Hegelich B. M.

2021, 6(1) doi: 10.1063/5.0026595

Abstract(121) FullText HTML (37) PDF(8)

Abstract:
An experimental and simulation study of warm dense carbon foams at ambient density (n_e ∼ 10²¹ cm⁻³) is presented. This study of isochorically heated foams is motivated by their potential application in carbon-atmosphere white-dwarf envelopes, where there are modeling uncertainties due to the equation of state. The foams are heated on an approximately picosecond time scale with a laser-accelerated proton beam. The cooling and expansion of the heated foams can be modeled with appropriately initialized radiation-hydrodynamics codes; xRAGE code is used in this work. The primary experimental diagnostic is the streaked optical pyrometer, which images a narrow band of radiation from the rear surface of the heated material. Presented are xRAGE modeling results for both solid aluminum targets and carbonized resorcinol-formaldehyde foam targets, showing that the foam appears to cool slowly on the pyrometer because of partial transparency. So that simulations of cooling foam are processed properly, it is necessary to account for finite optical depth in the photosphere calculation, and the methods for performing that calculation are presented in depth.

Projectile and target excitation in He⁺ + He collisions at intermediate energies

Gao Junwen, Hu Zhimin, Wu Yong, Wang Jianguo, Sisourat Nicolas, Dubois Alain

2021, 6(1) doi: 10.1063/5.0025623

Abstract(54) FullText HTML (19) PDF(4)

Abstract:
We present ab initio calculations of cross sections for projectile and target excitation occurring in the course of He⁺ + He collisions using a three-active-electron semiclassical nonperturbative approach. Intermediate impact energies ranging from 1 keV to 225 keV/u are considered. The results of our calculations agree well with available measurements for both projectile and target excitation in the respective overlapping energy regions. A comparison of our results with those of other theoretical calculations further demonstrates the importance of a nonperturbative approach that includes a sufficient number of channels. Furthermore, it is found that the cross sections for target excitation into singlet states show a valley centered at about 25 keV/u, resulting from competition with electron transfer to singlet projectile states. By contrast, the cross sections for target excitation into triplet states do not exhibit any such structures.

Optimization of a laser plasma-based x-ray source according to WDM absorption spectroscopy requirements

Martynenko A. S., Pikuz S. A., Skobelev I. Yu., Ryazantsev S. N., Baird C. D., Booth N., Döhl L. N. K., Durey P., Faenov A. Ya., Farley D., Kodama R., Lancaster K., McKenna P., Murphy C. D., Spindloe C., Pikuz T. A., Woolsey N.

2021, 6(1) doi: 10.1063/5.0025646

Abstract(315) FullText HTML (129) PDF(16)

Abstract:
X-ray absorption spectroscopy is a well-accepted diagnostic for experimental studies of warm dense matter. It requires a short-lived X-ray source of sufficiently high emissivity and without characteristic lines in the spectral range of interest. In the present work, we discuss how to choose an optimum material and thickness to get a bright source in the wavelength range 2 Å–6 Å (∼2 keV to 6 keV) by considering relatively low-Z elements. We demonstrate that the highest emissivity of solid aluminum and silicon foil targets irradiated with a 1-ps high-contrast sub-kJ laser pulse is achieved when the target thickness is close to 10 µm. An outer plastic layer can increase the emissivity even further.

The L4n laser beamline of the P3-installation: Towards high-repetition rate high-energy density physics at ELI-Beamlines

Jourdain N., Chaulagain U., Havlík M., Kramer D., Kumar D., Majerová I., Tikhonchuk V. T., Korn G., Weber S.

2021, 6(1) doi: 10.1063/5.0022120

Abstract(207) FullText HTML (84) PDF(10)

Abstract:
The P3 installation of ELI-Beamlines is conceived as an experimental platform for multiple high-repetition-rate laser beams spanning time scales from femtosecond via picosecond to nanosecond. The upcoming L4n laser beamline will provide shaped nanosecond pulses of up to 1.9 kJ at a maximum repetition rate of 1 shot/min. This beamline will provide unique possibilities for high-pressure, high-energy-density physics, warm dense matter, and laser–plasma interaction experiments. Owing to the high repetition rate, it will become possible to obtain considerable improvements in data statistics, in particular, for equation-of-state data sets. The nanosecond beam will be coupled with short sub-picosecond pulses, providing high-resolution diagnostic tools by either irradiating a backlighter target or driving a betatron setup to generate energetic electrons and hard X-rays.

Convective amplification of stimulated Raman rescattering in a picosecond laser plasma interaction regime

Ji Yu, Lian Chang-Wang, Yan Rui, Ren Chuang, Yang Dong, Wan Zhen-Hua, Zhao Bin, Wang Chen, Fang Zhi-Heng, Zheng Jian

2021, 6(1) doi: 10.1063/5.0026379

Abstract(116) FullText HTML (47) PDF(4)

Abstract:
We present particle-in-cell (PIC) simulations of laser plasma instabilities (LPIs) with a laser pulse duration of a few picoseconds. The simulation parameters are appropriate to the planar-target LPI experimental conditions on SG-II. In this regime, the plasmas are characterized by a long electron density scale length and a large electron density range. It is found that when the incident laser intensity is well above its backward stimulated Raman scattering (backward SRS, BSRS) threshold, the backscattered light via the primary BSRS is intense enough to excite secondary SRS (Re-SRS) in the region below one-ninth of the critical density of the incident laser. The daughter light wave via the secondary BSRS (Re-BSRS) is amplified as it propagates toward the higher-density region in the bath of broadband light generated through the primary BSRS process. A higher intensity of the incident laser not only increases the amplitude of the BSRS light but also increases the convective amplification lengths of the Re-BSRS modes by broadening the spectrum of the BSRS light. Convective amplification of Re-BSRS causes pump depletion of the primary BSRS light and may lead to an underestimate of the primary BSRS level in SP-LPI experiments. A significant fraction of the generation of energetic electrons is strongly correlated with the Re-BSRS modes and should be considered as a significant energy loss.

A model for defect formation in materials exposed to radiation

Davis Sergio, González-Cataldo Felipe, Gutiérrez Gonzalo, Avaria Gonzalo, Bora Biswajit, Jain Jalaj, Moreno José, Pavez Cristian, Soto Leopoldo

2021, 6(1) doi: 10.1063/5.0030158

Abstract(94) FullText HTML (32) PDF(1)

Abstract:
A simple model for the stochastic evolution of defects in a material under irradiation is presented. Using the master-equation formalism, we derive an expression for the average number of defects in terms of the power flux and the exposure time. The model reproduces the qualitative behavior of self-healing due to defect recombination, reaching a steady-state concentration of defects that depends on the power flux of the incident radiation and the material temperature, while also suggesting a particular time scale on which the incident energy is most efficient for producing defects, in good agreement with experimental results. Given this model, we discuss the integral damage factor, a descriptor that combines the power flux and the square of the irradiation time. In recent years, the scientific community involved in plasma-facing materials for nuclear fusion reactors has used this parameter to measure the equivalent material damage produced in experiments of various types with different types of radiation and wide ranges of power flux and irradiation time. The integral damage factor is useful in practice but lacks formal theoretical justification. In this simple model, we find that it is directly proportional to the maximum concentration of defects.

2021 Vol. 6, No. 1

Current Issue